icon

Application Instructions

APPLICATION INSTRUCTIONS

The car paint surface must be clean and free of dirt and wax prior to
application

Should Apply at temperatures between 80℃ and 120℃ to a smooth, flat
surface.

1. Trim CARLIKE® Vinyl Wrap to fit a proper location.

2. CARLIKE® Vinyl Wrap is produced with new air bubble free technology,
high density air channels, dry application is available, easy to install,
and save installation time.


3. Peel off CARLIKE® Vinyl Wrap from the liner paper at one end, and place
into position on the vehicle. Continue to remove the liner paper as you
apply using a squeegee to rub into place.


4. Initial low viscosity glue, adjust positioning the CARLIKE® Vinyl Wrap
on the car paint more quickly.


5. Inspect the application. Any bubbles can be punctured with razor
tip and carefully squeegee down.

6. Allow 24 hours before cleaning vehicle at an automatic or manual
high-pressure car wash.

HEAT FORMING

CARLIKE® vinyl film can be formed around some compound-curved
surfaces by using a hair dryer or heat gun. Use the tool to heat the film
(2 - 3 seconds) until it is stretchable, then start to wrap the film to the
contours/edge of the application surface.While the film is still
warm, use a squeegee or fingertips to apply pressure to the film to
help shape it to the contours. Be careful do not over-stretch the film
when it is heated.

If you wrinkle the film during installation,
let it cool and gently lift the film from the surface and re-apply.
The wrinkled film can be repaired to flat by heating.